$0.00
You are here:
< Back

 

How to setup the Kibosh Router:

  1. Plug Ethernet cable into Kibosh Router Internet Port <–> existing modem/router LAN port.
  2. Power on Kibosh Router, power cycle existing modem/router (i.e. reboot both devices)
  3. Look for krn600 WiFi – when you see it join using abcd0001
  4. Go to test.kibosh.net – if you get the Kibosh Success page proceed, if not repeat the above until you do.
    • At this point you can start using the Kibosh Router, and move everyone onto it.
  5. Log in at https://myfilter.kibosh.net and start managing your Kibosh Router.

How to setup the Kibosh Router after a reset to factory:

  1. Plug Ethernet cable into Kibosh Router Internet Port <–> existing modem/router LAN port.
  2. Power on Kibosh Router, power cycle existing modem/router (i.e. reboot both devices)
  3. Look for krn600 WiFi – when you see it join using abcd0001
  4. Go to test.kibosh.net – if you get the Kibosh Success page proceed, if not repeat the above until you do.
  5. Browse to http://192.168.10.1
    • Enter a password and your Kibosh ID + Connectivity Code which is your Kibosh ID in all caps (for both)
    • Save Changes
    • At this point you can start using the Kibosh Router, and move everyone onto it.
  6. Log in at https://myfilter.kibosh.net and start managing your Kibosh Router.

Need help? Email support@kiboshfilter.com, or call 888-727-3018.

Kibosh

The protector of their tomorrows since 2010.