Technical Support

  Preface: how to find your gateway, i.e. router IP. 1. Access the router’s browser-based utility. Log into your router’s browser-based utility by entering 192.168.0.1 or your default configuration IP into a browser. 2. Go to the “Advanced Setup” menu. Click on the “Advanced Setup” link. 3. Select the “WAN Settings” link from the left. Click “WAN Settings” from the “Broadband Settings /IP Addressing” section. 4. Change your DNS type. The options may differ depending on your firmware. Scroll down to…

  Preface: how to find your gateway, i.e. router IP. 1. Access the router’s browser-based utility. Log into your router’s browser-based utility by entering 192.168.0.1 or your default configuration IP into a browser. 2. Go to the “Advanced Setup” menu. Click on the “Advanced Setup ” link. 3. Select the “WAN Settings” link from the left. Click “WAN Settings” from the “Broadband Settings /IP Addressing” section. 4. Change your DNS type. The options may differ depending on your firmware. Scroll…

Preface: how to find your gateway, i.e. router IP. 1. Connect to the Management Interface. Connect to the CLI with ssh using an IP address of any of the IP Interfaces, such as the default of 192.168.1.254.  Alternatively you may use HyperTerm to connect directly to the serial console with the settings of 115200-8-N-1. HyperTerm Serial port settings: 2. Login to the Firewall. 3. Change the DNS settings to use Kibosh Shield. Once logged into the CLI then enter the configuration terminal. Type “config…

  Preface: how to find your gateway, i.e. router IP. 1. Connect to the Management Interface. Connect to the LSM with Firefox/Internet Explorer using an IP address of any of the IP Interfaces.    Example URL: https://192.168.1.254 2. Login to the Firewall. Login to the firewall as a user with administrative privileges. 3. Click DNS under Configuration to change DNS settings. 4. Type in Kibosh Shield addresses in DNS Server 1 and DNS Server 2 fields. Please write down your current DNS settings before switching to Kibosh Shield, in case you want to…

  This article is to assist with setting up Kibosh Shield on a TP-Link CR700 router. The original manual for this router can be found here: http://www.tp-link.com/res/down/doc/Archer_CR700_V1_UG.pdf Step 1. Type http://192.168.1.1 into your preferred web browser. NOTE: You will need to log in to access the router settings. The default login information can be found below. Username: admin Password: admin Step 2. Click on the Advanced tab located on the right side of the screen. Step 3. Navigate to LAN settings…